Drywall
New, bare, repaired, porous, or unevenly sealed drywall may need a compatible drywall primer. Sound previously painted drywall is evaluated for adhesion, sheen, stains, and spot-primer needs.
Trim and door standard
Emerald Urethane Trim Enamel
A durable, cleanable enamel for garage trim and doors, with Semi-Gloss standard and Satin available.
Why Ace Selected It
A Defined Job in the Garage System
It levels to a finished look and provides the harder, more cleanable surface that garage door and trim edges need.
- Applicable Ace surfaces
- trim, door
- Ace-offered finish
- Semi-Gloss standard; Satin alternate
- Published coverage
- 350–400 sq. ft. per gallon per coat
- Dry to touch
- 2 hours
- Recoat planning
- 4 hours
- Cure/use planning
- Allow the finish to cure before closing painted doors tightly or aggressive cleaning.
- Installed build
- Two finish coats over preparation and primer specified for the substrate
Before Coating
Preparation and Limitations
Preparation
- Existing finishes are cleaned, soundness-tested, dulled as needed, and primed where the substrate or repair requires it.
- Bare wood, metal, composite surfaces, and factory finishes are evaluated separately for adhesion and primer compatibility.
- Hardware, seals, and moving interfaces are protected so paint does not interfere with operation.
Important limits
- Not every door material or factory finish accepts the same preparation or primer.
- Dark colors can increase heat gain on sun-exposed doors; final suitability is confirmed on site.
After Installation
Cleaning and Real-World Use
After full cure, wipe with a soft cloth and compatible mild cleaner. Avoid abrasive pads that can change the sheen.
Moisture comes first
Paint improves a properly prepared surface; it does not fix active water entry, condensation, mildew, or failing drywall, wood, metal, or masonry. Ace documents repairs and exclusions in the written scope, consistent with the existing two-year painting warranty.
Primer Is a Scope Decision
Each Substrate Is Evaluated Separately
A customer chooses color and finish. Ace chooses compatible preparation and primer after inspecting the actual surface.
Block and masonry
Concrete block and masonry must be cured, clean, dry, and free of efflorescence or active moisture. Porosity and pH determine whether a masonry conditioner, block filler, or compatible primer is specified.
Wood
Bare wood, knots, tannin-prone species, and repaired areas are evaluated separately and receive a compatible primer when needed.
Metal
Rust, mill scale, oil, and failing factory finish must be addressed. Bare ferrous, galvanized, and previously coated metal require different adhesion and corrosion-control decisions.
Common Questions
Questions About Emerald Urethane Trim Enamel
Is Emerald Urethane Trim Enamel used on every garage surface?
No. Ace uses it for trim and door only. Walls, ceilings, trim, doors, and floors have different coating requirements.
Does this product remove a moisture problem?
No. Active leaks, condensation, mildew, efflorescence, and substrate failures must be corrected first. Paint is not moisture remediation, and those causes remain subject to the written painting warranty exclusions.
Is primer automatically included everywhere?
Primer is a scope decision, not a color option. Ace evaluates drywall, block or masonry, wood, metal, stains, repairs, and existing coatings separately and writes the required preparation into the quote.
How many finish coats does Ace apply?
The installed system is based on two finish coats over appropriate preparation. The current product data sheet, substrate, color, conditions, and written scope control the final application.
Plan the Complete Paint Scope
Measure walls and ceiling, select the product system, choose colors, and bring the validated plan into the existing cost estimator.
Your info stays private · Typical response: under 1 hour · No obligation